Rigid Washable Resin 601
High-performance photopolymer resin for 3D printers
$25.00
Water washable toughphotosensitive resin
Product Description：
DYODE Washable Series 601 is a high-precision resin that can be cleaned directly with water (without soap and water). ABS-like nature, suitable for LED light source wavelength 365nm-405nm printer.
产品性能：
01 Low shrinkage
DAYOUDE photosensitive resin is specially designed to reduce volume shrinkage during the light curing process, ensuring high precision and surface finish of printed models, and is suitable for printing high precision assembly parts.
02 High-speed curing
The washable series resins allow for very fast layer curing times, layer thicknesses of 25-300 microns, easy release, and resistance to pull-off at speeds up to 1-2 seconds!
03 High precision
The cured model has a hardness of 81D, providing superior hardness and durability, making it ideal as a fixture or fixing device where high strength is required.
04 High strength
The washable series resins have excellent mechanical strength and even better impact resistance, and can be tapped directly.
05 High elongation degree
The material has excellent elongation at break, and the printed models are not easily pulled off, ensuring successful printing.
06 Good stability
Washable series resins do not stratify or change color after a long period of time, do not clump, and the printed models are durable.
Technical parameters：
Test Items | Test Results |
Viscosity | 180-260cps@25℃ |
Critical exposure energy | 7.5 mJ/cm2 |
Tensile strength | 36-52MPa |
Tensile modulus | 1,799-2,385MPa |
Elongation at break | 4-8% |
Notched impact strength | 30-40J/m |
Heat deflection temperature | 77℃ |
Shore hardness | 81D |
Printing parameters：
Printer Type | Test Items | Test Results |
LCD Printers | General layer (electronic ink screen) | 1-5 秒 |
General Layer (Color LCD) | 3-8 秒 | |
Ground floor | 15-50 秒 | |
DLP Printers | General Layer | 1-3 秒 |
Ground floor | 15-30 秒 | |
Note | When using a large size LCD screen to print large size models, it is recommended to try to control 4-5s to prevent the model from being pulled off too fast. | |
Note: The above values may vary in actual values depending on part geometry, print settings, temperature variations, secondary post-curing, etc. Therefore, the user must test the product before use to ensure that it will meet your end-use requirements for print performance. The above values are typical values and we do not agree to them as binding material specifications or warranties unless expressly agreed to in writing. Final results depend on the actual use of the user, and this table is for reference only.